Aftermarket Kit Matching Instructions

Instructions:

To match an HHT Handheld transmitter with a C220 receiver, you must get both units into match mode. Put the C220 receiver into match mode, following these instructions:

• There are 2 magnets on the back of the HHT Handheld,  and a sensor under the Aarcomm logo at the top left corner of the C220 receiver. 

• Waive the two magnets across the sensor under the logo up to 5 or 6 times. 

• The light on the receiver will change from a white / light blue colour to a dark blue when C220 receiver is put into match mode.

Once the C220 receiver is in match mode, it is time to put the HTT transmitter into match mode as follows: 

• Make sure the remote control is powered off before continuing to the next step.

• Hold down the red button. When the red button is held down, you will see the red LED go on.

• Then, with your other hand, hold down the three circular buttons to the left of the red button and this will cause the green LED to go on.

• When both the red and green LEDs are on, take your fingers and thumb off the buttons. The top screen will then say, “match mode” and then a few seconds later “match mode successful.

• Turn off the receiver and then turn both the handheld and the receiver on again. Your system is now ready to operate.

If you see “Match Failed”, it could mean:

• The C220 was not powered on or did not enter match mode (the C220 is in match mode when the LED is dark blue), and the HHT Handheld waited too long and timed out after 60 seconds. When the HHT is put into match mode, it should match with a C220 that is in match mode within a few seconds.

OR

• There is incompatible software on the HHT and C220. Please contact our support team for further assistance at support@aarcomm.com or 1-800-604-9218.